Car carpet Tailored tailoring method
This method can be used in craft paper or newspaper to cut the car carpet size of the driving position and the rear position, so as to ensure the best effect.
Full circle of silk ring car carpet
1. The driving position of the car carpet needs to focus on the size. If the size is not suitable, it will leave a gap to cause the displacement of the foot pad, and the newspaper should be covered with a pen and then drawn on the corner.
2. After drawing the outline, cut off the cardboard (with the best effect of 0.5cm)
3.Vice driving position of the car carpet Pay more attention to is beautiful, it is recommended to play board, according to proper proportion to draw the line when to pay special attention to the upper right corner of the upper, due to the different Angle, Angle to avoid too high lead to MATS curl, can leave some blank appropriately.
4. When the cut is finished, put car carpet in the car to compare the size (to ensure that the cutting effect is more standard)
5. The back seat also needs to pay attention to the beautiful place. The car carpet tailoring method in the back seat can be divided into conjoined and separated parts, the newspaper will be spread to the back seat, and the line will be drawn along the back row.
6. Separate Body: after the plate is finished, according to the least amount of material, after the car carpet is arranged on the back, use the brush to draw the pattern.
Conjoined: 3 pieces of cardboard in the back row are glued together.Then put the back model on the car carpet and use the brush to draw the pattern.
The main specification of car carpet
1)Small and medium-sized five cars: three-piece or 1.5 * 1.2 m
2)small and medium-sized van: 1.2*2m ~ 1.2 * 3 m s
3)mall and medium-sized commercial vehicles: 1.2 * 2.5 m ~ 1.2 * 3.5 m
4)each type truck: (1.5 ~ 2.0 m )* 0.6 m,
5)trunk mat: 1.2 * 0.8 m ~ 1.2 * 1.5 m